Elenco Same as XP720 in Kit Form Uživatelský manuál stáhnout pdf (Strana 8)

-7-

r Install binding posts 1-7 with the colors in order, as shown in Figure D. Insert the post into the hole and fasten

it with the nut and lockwasher. Tighten down the nut with pliers.

r Cut off the tabs on the two potentiometers and install them with the lugs up, as shown in

Figure D. Secure in place with a 5/16” lockwasher, 8mm flat washer and 7mm nut.

r Turn both potentiometer shafts all the way counter-clockwise. Line up the line on the

knobs with the first line on the voltage scale. Press knobs onto the shaft of the

potentiometers.

r Note the lug configuration on the rocker switch. Push the switch into the hole in the

chassis with lug 1 on top as shown in Figure D.

PANEL ASSEMBLY

Figure D

Lug 1

Lockwasher

Nut

Black

Red

Black

Yellow

Rocker Switch

Rear View of Rocker Switch

7mm Nuts

8mm Washers

5/16” Lockwashers

Potentiometers

* Cut off tabs

Red

Yellow

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Žádné komentáře

Elenco Same as XP720 in Kit Form Uživatelský manuál Strana 8