Elenco Diode/Transistor Tester Kit Uživatelský manuál stáhnout pdf (Strana 8)

-7-

! Strip the insulation off both ends of the blue wire

to expose 1/4” of bare wire. Solder one end to the

hole on the copper side of the PC board, as

shown in Figure L. Solder the other end of the

wire to a lug on the push button switch.

! Solder the red wire from the battery snap to the

other lug on the push button switch, as shown in

Figure L.

! Insert the black wire from the battery snap into the

pad on the PC board from the copper side. Solder

the wire in place, as shown in Figure L.

Figure L

Mount the front panel to the switches on the PC

board using four M3 x 0.5 x 5mm screws (see

Figure M).

Figure M

M3 x 0.5 x 5mm ScrewsM3 x 0.5 x 5mm Screws

Blue wire

Push button switch

Battery snap

Black wire

Red wire

1 2 3 4 5 6 7 8 9 10 11 12

Žádné komentáře

Elenco Diode/Transistor Tester Kit Uživatelský manuál Strana 8